B 10s, Big 10, B112 and Simplicity 101

MyTractorForum.com - The Friendliest Tractor Forum and Best Place for Tractor Information

B 10s, Big 10, B112 and Simplicity 101

Old Allis Chalmers for sale
I know someone in Connecticut that has
1 Simplicity 101
1 Big 10 has hememade wheel weights and chains
One B112 with wheel weights and chains and
4 B10s
He is going to junk them...all but one he wants to keep......he told me I can have everything else for $800...all I want is either the Big 10 or the B112
All have mower decks...most tires are holding air...all "ran when parked" a few years ago...they have always been parked indoors
all fuel tanks look like they were drained when parked...any one interested in any of theses..I can't bear the thought of them going for scrap...and all I need and have room for is 1 of them

Kohler K341 engine block - NE Oklahoma

Very nice Kohler K341 engine block. Came off a John Deere 300. Should be good to go with a quick hone. Everything looks good no cracks.

Asking $100 plus shipping. PM with questions, etc.

what steel tubing for FEL Hydraulics??

Hello all!

I gearing up to make some upgrades on my ford 3600 / 772 loader.. Im going to invert the lift cylinders, run the lines on the main loader arms, and add quick connects..

What type tubing is used ??? Is it just a carbon steel?? What thickness is plenty heavy but allows for some bending??? Im seeing 1/16", 3/64, and 1/32" wall on Grainger..

Thanks all!!!

Help with a 345 lawn tractor not mowing in reverse

Hello

I have a John Deere 345, purchased new 99. It will not mow in reverse, even with the pto switch in the up position. Thought it was just the switch, but the new one doesn't work either. Temporarily bypassed the seat switch to see if it was that and that didn't work. Any suggestion? No reverse mowing is a pain in the butt. Thanks.

Ford Town & Country returning to its' White roots

Everytime time I power wash the painted over Jake built "Ford", it gets a little closer to becoming a "White Town & Country" once again.

Well, a "red" White anyway.:tango_face_devil:

.Attachment 2335587Attachment 2335581
Note seat pan insulators bumped up from 5/16" to 3/8". One original missing at the foot rest.


.Attachment 2335583Attachment 2335585

Attached Thumbnails

       

Speedy tractors

But can they plow? Couple fast moving tractors. Go to 4:20 for the Volvo and then it's followed by a speed of light Massey at 4:35.
Hang on to your hat.

MikeC

Oil thru fuel pump 917.258920

The engine is a Kohler Command CV25. I recently installed the updated head gasket, new fuel pump and clean/adjusted everything. Motor runs great. After a couple hours of cutting grass in pretty tough environment, oil was all over both valve covers. I’m pretty sure neither valve cover is leaking but oil is blowing through the vacuum line of the new fuel pump and out the PCV tank which vents from the other valve cover (opposite the fuel pump). Pretty sure the new head gasket is not leaking compression into the vacuum trail. Any thoughts on why oil is coming out the vent on the fuel pump and PCV valve?

Thanks
Rich

Grand Sierra with Haban 409 Sickle.

Installed it in today. Boy these suckers are heavy

trans swap 4x5 into x720

I have an extra 4x5 trans and is it the same as the unit in a x720? the x 720 has a bad unit I believe the unit I have is a K91